IR remote extender schematic

Posted by ATMAJA'Z

IR remote extender schematic image

This project describes how to build an IR remote control extender / repeater to control your electronic appliances from a remote location.

An IR detector module receives IR signal from remote control and two IR leds are re-emitting the signal to the appliance. You can place the IR emitting leds close to the device you would like to control using some wire and keep main unit close to remote control location. In the image at the left LEDs are soldered on the board. The circuit consists of three main parts, the IR receiver module, a 555 timer configured as an oscillator and the output / emitter stage. We will describe circuit operation below.

Circuit is designed by Andy Collinson and can be found here: http://www.zen22142.zen.co.uk

source: http://www.electronics-lab.com/